TECHNIQUE OF CREATION OF PROFILE OF DISK CROSS SECTION

A choice of the sizes and form of a disk is made for the set operation conditions on the basis of geometrical ratios between parameters of a disk and their admissible values developed by practice. Except the crumbling and turning ability of a disk the add factors influencing on its geometrical and power parameters are non-crumple condition of a vertical wall of a furrow and steady raising of layer on a curvilinear surface of operation sector. Basic data for construction horizontal, cross-vertical, longitudinal-vertical projections is diameter of a disk, an angle of attack, running depth. Depth of the course images a chord of disk dip on cross-vertical and longitudinal-vertical projections of a disk. The disk sphere which excludes crumple of a vertical wall of a furrow at its movement is designated on the horizontal projection. Criterion of disk efficiency a is possible soil sliding along a curve of longitudinal-vertical projection within limits of the lowermost point and a point excluding crumple of the furrow vertical wall and located on a chord of deep. The parameter of a curve of possible sliding can be defined taking into account that the sum of multiplications of tangent efforts to a projection of a trajectory of the movement of an elementary platform less than zero. Taking into account the received value we can construction the sliding curve on the longitudinal-vertical projection in a zone of operating surface. Points of intersection of the sliding curve with the generating lines of longitudinal-vertical projection are moved by horizontal transfer on a piece of an interval of the horizontal projection. On three points we create a profile of a disk on height of a placement of the generating lines. The disk profile with the spherical or flat bottom should be create at the level of generating lines of cross-vertical projection taking into account the intervals placed on a perpendicular to the center of diameter of a disk of a horizontal projection.

почвообработка, дисковый рабочий орган, хорда погружения, радиус сферы, кривая скольжения, Soil cultivation, Disk working element, Deep chord, Sphere radius, Sliding curve

1. Лобачевский Я.П., Эльшейх А.Х. Обоснование расстановки дисковых рабочих органов в комбинированных почвообрабатывающих агрегатах // Сельскохозяйственные машины и технологии. - 2009. - № 4. - С. 22-25

2. Измайлов А.Ю., Сидоров С.А., Лобачевский Я.П., Хорошенков В.К., Кузнецов П.А., Юрков М.А., Голосиенко С.А. Научные принципы повышения изностойкости рабочих органов почвообрабатывающей техники // Вестник Российской академии сельскохозяйственных наук. - 2012. - № 3. - С. 5-7

3. Лобачевский Я.П., Старовойтов С.И., Чемисов Н.Н. Энергетическая и качественная оценка рабочего органа // Сельскохозяйственные машины и технологии. - 2015. - № 5. - С. 10-13

4. Старовойтов С.И. Исследование процесса и разработка чизельного культиватора для работы в плодово-ягодных насаждениях: Дисс…. канд. техн. наук. - М.: ВТИИСП, 1994. - С. 82

5. Лобачевский Я.П. Новые почвообрабатывающие технологии и технические средства // Механизация и электрификация сельского хозяйства. - 2000. - № 8. - С. 30-32